Mult'ing Tracks in DP (i.e. Drums)
Posted: Sat Jul 17, 2010 7:04 pm
Greetings all,
I am using DP 6.03/Dual 2.0 G5 PPC 6GB RAM/PCI-424/1224&2408 MKI.
How can I mult (drum) tracks in DP 6? I have searched this site over and the DP manual and find nothing. I know most of you know what I'm referring to. It is is somewhat similar to busing but, it's additive outputting the tracks instead of busing tracks to an aux. You have a duplicate output of the chosen tracks. If any of you use PT, in PT while selecting your track(s) ouputs, you can hold down (I think, can't remember) shift/option (?) and can now multiply your outputs.
Ex. Drum tracks>shift/option pull down output assignments>you can add say bus 1&2 along with Analog out 1&2. I now would have duplicates outputting of my drum tracks-#1 all drums are outputting to Aanal of 1&2, #2 in addition to outputting to bus 1&2. This way, on the mult'ed aux bus I can (heavy) compress the entire drum tracks as a stereo bus. This is in addition to the individual track plugins (EQ's, Compression) that are outputted to Analog 1&2.
Do I have to set this up in the Bundles section? So far the work around I've used is assigning bus sends on each track, setting the send amount the same as my track fader level, and setting the send pan the same as my track pan. This is obviously not the way to mult tracks.
Hope all this made since and I'm sure most of you know what I'm saying, especially if you're familiar w/ doing this in PT.
Regards
Keith
I am using DP 6.03/Dual 2.0 G5 PPC 6GB RAM/PCI-424/1224&2408 MKI.
How can I mult (drum) tracks in DP 6? I have searched this site over and the DP manual and find nothing. I know most of you know what I'm referring to. It is is somewhat similar to busing but, it's additive outputting the tracks instead of busing tracks to an aux. You have a duplicate output of the chosen tracks. If any of you use PT, in PT while selecting your track(s) ouputs, you can hold down (I think, can't remember) shift/option (?) and can now multiply your outputs.
Ex. Drum tracks>shift/option pull down output assignments>you can add say bus 1&2 along with Analog out 1&2. I now would have duplicates outputting of my drum tracks-#1 all drums are outputting to Aanal of 1&2, #2 in addition to outputting to bus 1&2. This way, on the mult'ed aux bus I can (heavy) compress the entire drum tracks as a stereo bus. This is in addition to the individual track plugins (EQ's, Compression) that are outputted to Analog 1&2.
Do I have to set this up in the Bundles section? So far the work around I've used is assigning bus sends on each track, setting the send amount the same as my track fader level, and setting the send pan the same as my track pan. This is obviously not the way to mult tracks.
Hope all this made since and I'm sure most of you know what I'm saying, especially if you're familiar w/ doing this in PT.
Regards
Keith