I monitor a quite significant input level at the S/PDIF inputs but I have nothing attached to these ports (see figure)! Where can that come from?
Thanks for any hints.
Signal on S/PDIF in UltraLite
Moderator: James Steele
Forum rules
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Discussion related to installation, configuration and use of MOTU hardware such as MIDI interfaces, audio interfaces, etc. for Mac OSX
Signal on S/PDIF in UltraLite
Hi all
I monitor a quite significant input level at the S/PDIF inputs but I have nothing attached to these ports (see figure)! Where can that come from?
Thanks for any hints.
I monitor a quite significant input level at the S/PDIF inputs but I have nothing attached to these ports (see figure)! Where can that come from?
Thanks for any hints.
Re: Signal on S/PDIF in UltraLite
Mine does that too sometimes. I've found it to vary based on whether I'm bus or wall-powered. I think it's a fault I should send it in for, but since I don't use S/PDIF on this interface it's not a big deal.
I remember there also being S/PDIF issues with the 1st gen Traveler I used. Something similar though I don't recall clearly.
I remember there also being S/PDIF issues with the 1st gen Traveler I used. Something similar though I don't recall clearly.